Introduction
If you are having issues with your PAS not working on a Juggernaut Hub Duo eBike you may need to disconnect the Gear Shift Sensor.
To do this you will need the following tools:
- 2.5mm Allen Key
Cancel
Disconnecting Hub Duo Gear Shift Sensor
Step 1
-  Remove any batteries from the bike and discharge any excess power from the system by holding the POWER button on your display. Â
- Open up the controller compartment on the non-drive side of the bike. To do this remove the 4 circled screws with a 2.5mm Allen Key.
- With the screws removed take off the cover.