With the application launched you will see a screen with some information as shown in this first image.

With the correct COM port that your bike is connected to selected press the Connect button to establish the connection between the application and your eBike.
With your bike connected click the Read Flash button. This will populate the screen with whatever values are programmed onto the controller presently. Note that you may need to click this button twice.
VERY IMPORTANT - MAKE SURE YOU FOLLOW THESE NEXT STEPS TO BACKUP THE EXISINGTING SETTINGS ON YOUR BIKE!!!!!
Click on File and click on Save as seen in the second image.
Give a name to the file as shown in the third image and enter the .el extension at the end.

For example enter the name like this including .el at the end: Original_Settings_JuggernautClassic.el
Also, take note of where this file is saved on your computer - take a screenshot or picture of your screen with a cell phone camera.

Go to the destination folder where you saved the backup of your settings to confirm they are there.

Pedal Assist