1: BMS ERROR
BMS Display Area shows current battery voltage and any error codes which may be triggering from the bike.
2: Current Power Output
Shows the current discharging from the battery which corresponds to the amount of power the bike is using.
3: Riding Mode
Shows current riding mode. This will change as you use different PAS Levels. Levels 1 and 2 are ECO Mode, Level 3 and 4 are Normal Mode and level 5 is Sport Mode.
4: Battery Level
Shows the remaining battery capacity. Each segment represents approximately 20% of the battery’s capacity.
5: Backlight/Headlight Indicator
Signals if the headlight and display backlight is powered on.
6: Walking Mode Indicator
Icon lights up if walking mode is turned on.
7: Speed Display Unit
Unit being used for measurement of speed and distance will be lit up; either KM/H or MPH.
8: Speed Display
Displays current bike speed.
9: Riding Information Display
Toggles between different pieces of riding information:
- ODO: Total mileage the bike has been rode
- Trip 1: Trip Meter #1
- Trip 2: Trip Meter #2 (resets after powering off display)
- Time: Time spent powered on (resets after powering off display)
Lights up when in the SETUP interface
11+ 12: PAS
Displays the current PAS mode selected
Powering On/Off Display
Press the POWER button to turn on your display. Press and hold the POWER button again to turn the display off. Display will also turn off after 5 minutes of inactivity.
Choosing your Assist Level
Press the UP button to increase assist level. Press the DOWN button to decrease assist level. Level 0 means no assist is being used.
Operating the Headlight
With the display powered on tap the POWER button to turn on the headlight and the display’s back light. Tap the POWER button again to turn off the headlight and display back light.
Using Walking Mode
Hold the DOWN button for 2 minutes when the bike is stationary and in an assist mode to enter Walking Mode. This will turn the motor to move the bike forward at a speed of 6km/h. Use it when you need motor assistance to move the bike but cannot ride it. To exit this mode, release the DOWN button.
Toggling information in the Riding Information Display area
Press the SET button to toggle between information in this section. The information will toggle through in the following order: ODO -> Trip 1 -> Trip 2 -> Time
Changing Display Settings
Entering the Settings Interface
To enter the settings interface press and hold the SET button for 3 seconds. Exit this mode and save your changes by holding down the SET button for another 3 seconds.
Reset Trip Distance
Set 1 will be displayed. Press and hold the DOWN button to reset the TRIP 1 distance. Press the SET button again to advance to the next setting.
Change Max Speed Limit
Set 2 will be displayed. Use the UP and DOWN buttons to adjust the Max Speed limit that the motor will accelerate up to. The motor will no longer function above this speed however you can still go faster with the pedals. Press the SET button when done to save changes and advance to the next setting.
Change Wheel Diameter
Set 3 will be displayed. This does not need to be changed unless you are switching to a different sized wheel on your bike. Use the UP and DOWN buttons to change wheel size and press the SET button to save your selection and advance to the next setting.
Change Speed and Distance Units Displayed
Set 4 will be displayed. Use the UP and DOWN buttons to change the units used by the display for speed and distance. These can be toggled between KM/H and MPH. Press the SET button when changed to your preferred selection to save the setting.
Default Voltage Selection - SET 5
You do not need to change this – it will be set correctly from the manufacturer.