Biktrix Swift - Assembly Guide Follow
Overview
- Open the box and remove the main bike body.
- Remove all packing material from the bike.
- Remove the front wheel from the box and install. The fender will be attached to the front tire
- Install stem
- Install front wheel
- Install pedals
- Install front fender and headlight
- Install seat post
Your bike should now be ready to ride. If you are having any difficulties with this
assembly, please contact us or take your bike to a local bicycle shop
_____________________________________________________________________________________________
How to install Stem/Handlebars on Swift
- Insert the bottom of the stem into the head tube making sure the cap is on and the minimum insertion marks are covered
- Tighten top bolt (6mm Hex) with stem straight inline with the front wheel
- Adjust stem angle by loosening side bolt shown above
- After the desired stem angle found adjust the handlebar angle and tighten the four bolts on the front of the stem with a 4mm hex key
_____________________________________________________________________________________________
How to Install Front Wheel
*Depending on the box the bike was shipped in, the front wheel may already be installed*
- Locate Quick Release skewer in charger box
- Unscrew one side and remove one spring
- Insert skewer with lever one the brake side
- Slide spring onto a skewer with the smaller cone towards the wheel
- Screw on end nut 1 turn
- Remove protector and slide fork onto wheel while carefully aligning brake rotor into the caliper
- With bike upright and weight on the front tighten end nut on a skewer and close cam lever (cam lever is tight when it has resistance at 50% of closer, then close all the way)
_____________________________________________________________________________________________
How to Install Pedals
- Apply a small amount of grease to the pedal threads
- Note there is a right and a left pedal, they have different thread directions and are labelled with an R and L respectively
- Insert the right pedal into the right crank arm, turn the pedal axle clockwise to tighten, use a
15mm pedal wrench to tighten - Insert the left pedal into the left crank arm, turn the pedal axle anti-clockwise to tighten,
use a 15mm pedal wrench to tighten
_____________________________________________________________________________________________
How to Install Fender and Headlight
- Locate the fender hardware:
- 2x M5x bolts (on bottom of the fork)
- Attach both fender and headlight to upper mount in the order: Washer, headlight, fork, fender, washer then locknut,
- Attach fender stay eyelets to lower mounts on each side
Note: If fender is rubbing on wheel,
- Loosen the upper mount and adjust the slotted mount to clear the tire.
- If rubbing on the side the metal stay can be bent as needed to clear
_____________________________________________________________________________________________
How to Install Seat Post
- Apply a small amount of grease to the lower portion of the post-
- Open cam lever on seat collar
- Slide post to the desired height (seat post has a minimum insertion lever marked on it,
make sure this line is completely hidden within the frame) - Close cam lever (cam lever is tight when it has resistance at 50% of closer, then close
all the way)
Comments
0 comments
Please sign in to leave a comment.