Kutty LT Assembly Follow
How to Install Pedals
- Apply a small amount of grease to the pedal threads
- Note there is a right and a left pedal, they have different thread directions and are labeled with an R and L respectively
- Insert the right pedal into the right crank arm, turn the pedal axle clockwise to tighten, use a
15mm pedal wrench to tighten - Insert the left pedal into the left crank arm, turn the pedal axle anti-clockwise to tighten,
use a 15mm pedal wrench to tighten
How to Install Seat Post
- Apply a small amount of grease to lower portion of post-
- Open cam lever on seat collar
- Slide post in to desired height (seat post has a minimum insertion lever marked on it,
make sure this line is completely hidden within the frame) - Close cam lever (cam lever is tight when it has resistance at 50% of closer, then close
all the way)
How to Install Fender and Headlight
- Locate the fender hardware:
- M6 Bolt w/ nut on top of the fork
- Attach both fender and headlight to upper mount in the order: Washer, headlight, fork, fender, washer then locknut,
- Attach fender stay eyelets to lower mounts on each side
How to Install Front Wheel
- Locate Quick Release skewer in charger box
- Unscrew one side and remove one spring
- Insert skewer with lever one the brake side
- Slide spring onto a skewer with smaller cone towards the wheel
- Screw on end nut 1 turn
- Remove protector and slide fork onto wheel while carefully aligning brake rotor into the caliper
- With bike upright and weight on the front tighten end nut on a skewer and close cam lever (cam lever is tight when it has resistance at 50% of closer, then close all the way)
Note: If fender is rubbing on wheel,
- Loosen upper mount and adjust the slotted mount to clear the tire.
- If rubbing on the side the metal stay can be bent as needed to clear
Comments
0 comments
Please sign in to leave a comment.