Stunner X Assembly Follow
Overview
- Open the box and remove the main bike body.
- Remove all packing material from the bike.
- Remove the front wheel from the box and install. The fender will be attached to the front tire
- Install Handlebars
- Install Front Wheel
- Install Pedals
- Install Front Fender and Headlight
- Install Seat Post
Your bike should now be ready to ride. If you are having any difficulties with this
assembly, please contact us or take your bike to a local bicycle shop
How to install Handlebars on Stunner X
- The bottom of the stem into the head tube making sure the cap is on and the minimum insertion marks are covered
- Tighten top bolt (6mm Hex) with stem straight inline with the front wheel
- Adjust stem angle by loosening side bolt and locking plate on the bottom shown here:
- After the desired stem angle found adjust the handlebar angle and tightening the top 2 bolts on the stem
How to Install Front Wheel
- Locate Quick Release skewer in charger box
- Unscrew one side and remove one spring
- Insert skewer with lever one the brake side
- Slide spring onto a skewer with a smaller cone towards the wheel
- Screw on end nut 1 turn
- Remove protector and slide fork onto wheel while carefully aligning brake rotor into the caliper
- With bike upright and weight on the front tighten end nut on a skewer and close cam lever (cam lever is tight when it has resistance at 50% of closer, then close all the way)
How to Install Pedals
- Apply a small amount of grease to the pedal threads-
- Note there is a right and a left pedal, they have different thread directions and are labelled with an R and L respectively
- Insert the right pedal into the right crank arm, turn the pedal axle clockwise to tighten, use a
15mm pedal wrench to tighten - Insert the left pedal into the left crank arm, turn the pedal axle anti-clockwise to tighten,
use a 15mm pedal wrench to tighten
How to Install Fender and Headlight
- Locate the fender hardware:2
- 2x M5 bolts (on bottom of the fork)
- M6 Bolt w/ nut on top of the fork
- Attach both fender and headlight to upper mount in the order: Washer, headlight, fender, fork, washer then locknut.
- Attach fender stay eyelets to lower mounts on each side
Note: If fender is rubbing on wheel,
- Loosen the upper mount and adjust the slotted mount to clear the tire.
- If rubbing on the side the metal stay can be bent as needed to clear
How to Install Seat Post
- Apply a small amount of grease to the lower portion of the post-
- Open cam lever on seat collar
- Slide post into desired height (seat post has a minimum insertion lever marked on it,
make sure this line is completely hidden within the frame) - Close cam lever (cam lever is tight when it has resistance at 50% of closer, then close
all the way)
Comments
0 comments
Please sign in to leave a comment.