Stunner Assembly Follow
Overview
- Open the box and remove the main bike body.
- Remove all packing material from the bike.
- Remove the front wheel from the box and install. The fender will be attached to the front tire
- Install stem
- Install Pedals
- Install seat and post on bike
- Install front fender and headlight
- Install front wheel
Your bike should now be ready to ride. If you are having any difficulties with this
assembly, please contact us or take your bike to a local bicycle shop
How to install Stem/Handlebars on Stunner
- Open the stem cam lever by sliding the release button on the left-hand side of the stem
- Tighten the top bolt with the 5mm hex key until there is no play between the fork and the bottom of the headtube. Having this bolt too tight will cause stiff steering and excess bearing wear
- Adjust the handlebars to be straight and tighten the two side bolts on the stem evenly until the stem is secure
- Open the cam lever to adjust the angle of the handlebars and close once the desired angle is found. use a 5mm hex to tighten the top bolt if the handlebars are too loose once the cam lever is closed
How to Install Pedals
- Apply a small amount of grease to the pedal threads-
- Note there is a right and a left pedal, they have different thread directions and are labeled with an R and L respectively
- Insert the right pedal into the right crank arm, turn the pedal axle clockwise to tighten, use a
15mm pedal wrench to tighten - Insert the left pedal into the left crank arm, turn the pedal axle anti-clockwise to tighten,
use a 15mm pedal wrench to tighten
How to Install Seat Post
- Apply a small amount of grease to lower portion of post-
- Open cam lever on seat collar
- Slide post in to desired height (seat post has a minimum insertion lever marked on it,
make sure this line is completely hidden within the frame) - Close cam lever (cam lever is tight when it has resistance at 50% of closer, then close
all the way)
How to Install Fender and Headlight
- Locate the fender hardware:
- 2x M5x bolts (on bottom of the fork)
- M6 Bolt w/ nut on top of the fork
- 2x M5x bolts (on bottom of the fork)
- Attach both fender and headlight to upper mount in the order: Washer, headlight, fork, fender, washer then locknut,
- Attach fender stay eyelets to lower mounts on each side
How to Install Front Wheel
- Locate Quick Release skewer in charger box
- Unscrew one side and remove one spring
- Insert skewer with lever one the brake side
- Slide spring onto a skewer with smaller cone towards the wheel
- Screw on end nut 1 turn
- Remove protector and slide fork onto wheel while carefully aligning brake rotor into the caliper
- With bike upright and weight on the front tighten end nut on a skewer and close cam lever (cam lever is tight when it has resistance at 50% of closer, then close all the way)
Note: If fender is rubbing on wheel,
- Loosen upper mount and adjust the slotted mount to clear the tire.
- If rubbing on the side the metal stay can be bent as needed to clear
Comments
0 comments
Please sign in to leave a comment.